DCS - SCADA running on Linux and Windows. Development environment C/C++. The HMI is based on QT. Different technologies (EiC, GigaBASE, FastDB, ORTE) have been integrated. OPC DA 2.05a, A&E 1.10, HDA 1.20, DNP3, RFC 1006, Modbus, MQTT 3.1.1, IEC 60870-5-101/103/104 are supported
The PMU Connection Tester, administered by the Grid Protection Alliance (GPA), verifies that a data stream from synchrophasor measurement device is being successfully received. The PMU connection tester supports the following phasor data protocols: IEEE C37.118 (Version 1/Draft 7, Draft 6), IEEE
... [More] 1344, BPA PDCstream, SEL Fast Message, UTK FNET streaming data protocol, IEC 61850-90-5 and Macrodyne. [Less]
Creates multiple streams from a single synchrophasor stream source.
This service based application allows you to take one incoming stream of synchrophasor data (e.g., from a substation with limited bandwidth) and redistribute the stream as many times as needed. All common synchrophasor protocols
... [More] are supported (e.g., IEEE C37.118, IEC 61850-90-5, IEEE 1344, F-NET, SEL Fast Message, Macrodyne and BPA PDCstream) . This tool does not disaggregate streams into points - it resends exactly what was received. Manager and console applications can be run remotely - active configuration can be downloaded, edited and uploaded from management tool. Configuration is stored as an XML file. Full support for incoming and outgoing UDP, TCP, IPv6, and IPv4 in all combinations. [Less]