S

Smoothieware

Settings | Report Duplicate

1

I Use This!

Very Low Activity

Commits : Listings

Analyzed about 17 hours ago. based on code collected about 17 hours ago.

Commit Message	Contributor	Files Modified	Lines Added	Lines Removed	Code Location	Date
Jun 26, 2024 — Jun 26, 2025 Showing page 1 of 145 Search / Filter on:
Add -r to send ok on a noncontinuous $J command	Jim Morris	More...				8 months ago
Add progress to grid probing debug output	Jim Morris	More...				about 1 year ago
update latest bins	Jim Morris	More...				over 1 year ago
Hanlde $J STOP command in switch	Jim Morris	More...				over 1 year ago
update bins	Jim Morris	More...				almost 2 years ago
make M3 and M5 wait for idle in robot as well	Jim Morris	More...				almost 2 years ago
more optimization	Jim Morris	More...				almost 2 years ago
change name	Jim Morris	More...				almost 2 years ago
optimize stepticker	Jim Morris	More...				almost 2 years ago
minor fix	Jim Morris	More...				almost 2 years ago
improve robustness of the max31855 so errors returned by the sensor will eventually be recorded as a bad sensor	Jim Morris	More...				almost 2 years ago
Fix S being set to zero by M5 if a laser module is enabled Update latest bins	Jim Morris	More...				almost 2 years ago
Fix switch state on halt update latest builds	Jim Morris	More...				almost 2 years ago
update latest bins	Jim Morris	More...				over 2 years ago
increase dp of s	Jim Morris	More...				over 2 years ago
If laser is not enabled then mak ethe query S be current spindle speed set with M3 cleared with M5	Jim Morris	More...				over 2 years ago
set HWPWM and SWPWM switch state to off if it is less than or equal to the default off value	Jim Morris	More...				over 2 years ago
update latest firmware bins	Jim Morris	More...				over 2 years ago
fix	Jim Morris	More...				over 2 years ago
update latest bins	Jim Morris	More...				over 2 years ago
Allow $J to specify F or S to set feedrate	Jim Morris	More...				over 2 years ago
update firmware bins	Jim Morris	More...				over 2 years ago
update latest bin	Jim Morris	More...				over 2 years ago
don't send temperature as inf as Pronterface gets upset, change to -100	Jim Morris	More...				over 2 years ago
update latest bins	Jim Morris	More...				over 2 years ago
make sure the continuous jog mode is not run too slow and will move a minimum of 1mm	Jim Morris	More...				over 2 years ago
remove redundant function theta()	Jim Morris	More...				over 2 years ago
fix typo on mac address in sample configs	Jim Morris	More...				about 3 years ago
on resume from suspend move to XY first then Z	Jim Morris	More...				about 3 years ago
add option to allow heaters to be left on when suspend is called	Jim Morris	More...				about 3 years ago

←
1
2
3
4
5
6
7
8
9
…
144
145
→